The end of 2019

The end of 2018

The end of 2017

Five problems in plastic mold industry

Although the products of some enterprises have reached or approached the international advanced level, there is still a big gap between the accuracy of the mould, the roughness of the cavity surface, the production cycle and the service life compared with the foreign advanced l…

Notes on plastic mould

With a good mold, but also have good forming processing, the best is a one-stop cooperation, try to avoid multi cooperation. If the conditions are not met, one party should be fully responsible for the contract, and it must be written clearly at the same time.

Introduction of stamping die materials

Low alloy tool steel is based on carbon tool steel with appropriate alloy elements. Compared with the carbon tool steel, the quenching deformation and cracking tendency are reduced, the hardenability and wear resistance of the steel are improved. The low alloy steels used in mould m…